Function / Parameter Not Implemented

What does 8.0.00.11 mean?

The specific function or parameter being requested is not implemented in the current inverter's firmware or hardware configuration. This can occur if the inverter unit does not support a particular feature, or if a required optional module is missing. The requested operation cannot be performed.

• Attempting to use a feature (e.g., specific braking mode, advanced control algorithm) that requires an optional hardware module (e.g., braking resistor module, encoder option card) which is not installed.
• Requesting access to a parameter (e.g., P5-10 for an advanced motion profile) that is only available in a higher-tier inverter model or a newer firmware revision than the current unit.
• A legacy PLC program attempting to set a parameter that has been deprecated or replaced by a different parameter in a newer inverter firmware version.

Click steps to track your progress.

1. 1

   Verify the inverter model, firmware version, and installed option cards against the feature requirements for the desired parameter or function (e.g., confirm option card X30 is present for advanced I/O).

2. 2

   Review the inverter's parameter manual (specific to the installed firmware version) to confirm the existence and availability of the parameter in question.

3. 3

   Consider upgrading the inverter's firmware to a newer version (if available and compatible) that includes the desired functionality, following manufacturer guidelines and backup procedures.

4. 4

   If the function requires an optional hardware module, identify and install the correct module (e.g., encoder feedback card) into the designated slot (e.g., slot A or B) as per the installation manual.

5. 5

   Modify the control program (PLC/HMI) to only use parameters and functions supported by the current inverter hardware and firmware configuration (e.g., changing P5-10 to P5-01 if 5-10 is not implemented).