Overvoltage during charging, KPP/KSP (axis)

Hva betyr 26048 ?

An overvoltage condition occurred during the charging phase of the KPP or KSP module for a specific axis. This could be due to excessive mains voltage or an insufficient number of connected capacitance modules.

• Mains voltage is too high.
• Too few capacitors connected (insufficient modules) for the system requirements.

Klikk på steg for å spore fremgangen.

1. 1

   Measure mains voltage and verify it is within specified limits.

2. 2

   Verify the correct number of capacitor modules are connected.

3. 3

   Reinitialize the drive bus: Power Off / Power On.

4. 4

   Check the KPP module.