P1 240V AC Discon

Hva betyr 11120 ?

The 240V AC disconnect switch on port 1 is open when the precharge controller is in the ready state, but the molded case switch (MCS) is not closed. This prevents the drive from starting or operating.

• The main 240V AC disconnect switch (Port 1) is physically open or improperly closed.
• Failure of the auxiliary contact on the disconnect switch (Port 1) to provide closure feedback to the controller.
• Broken or loose wiring connecting the disconnect switch auxiliary contact (Port 1) to the drive's input status terminals.
• Faulty input status monitoring circuit on the drive control board (Port 1) for the disconnect switch.
• Incorrect drive parameter setting (e.g., Parameter P1-03 for Port 1) expecting a closed disconnect when it's open.

Klikk på steg for å spore fremgangen.

1. 1

   Physically confirm the 240V AC disconnect switch (Port 1) handle is fully in the CLOSED position.

2. 2

   Measure continuity across the auxiliary contacts (e.g., terminals 13/14) of the 240V AC disconnect switch (Port 1) when closed.

3. 3

   Trace and inspect the wiring from the disconnect switch auxiliary contacts (Port 1) to the drive's digital input terminals (e.g., DI1, DI2).

4. 4

   Verify the status of the corresponding digital input (e.g., Digital Input 1 status) on the drive's display for Port 1.

5. 5

   Check drive parameters (e.g., Parameter P1-03, 'Disconnect Input Selection' for Port 1) to ensure correct configuration for the disconnect input.