SYNCHRONIZE ADJUST MODE
Fanuc · Series 0i-D/0i Mate-D Maintenance
¿Qué significa DS0003 ?
This Fanuc Series 0i-D/0i Mate-D alarm indicates that the system is currently in the synchronize adjust mode. This is typically an operational status rather than a fault, meaning the machine is in a special mode for setup or calibration.
Causas comunes
- The machine was intentionally put into 'Synchronize Adjust Mode' for maintenance or setup purposes.
- Operator inadvertently entered the 'Synchronize Adjust Mode' without intending to.
- A sequence error or parameter setting caused the system to enter this mode unexpectedly.
Pasos de reparación & Lista de verificación
Haga clic en los pasos para seguir su progreso.
- 1
Verify if the machine was intentionally placed into 'Synchronize Adjust Mode' for maintenance or setup procedures.
- 2
Locate the control panel switch or software function used to enter and exit 'Synchronize Adjust Mode' and exit it.
- 3
If unable to exit the mode, check relevant system parameters or diagnostic screens for status indications.
- 4
Consult the machine's operation manual for the specific procedure to properly enter and exit this mode.
- 5
Ensure no active NC program or PMC ladder logic is inadvertently commanding the system into this mode.