Workpiece probe data incorrect or inactive

Hva betyr 61427 ?

The tool data for the active workpiece probe is either incorrect or the probe itself is inactive. This prevents accurate measurement operations. The error code (%4) indicates if the workpiece probe (or tool edge) is inactive, or if the length L1 of the workpiece probe is set to zero.

• Workpiece probe tool data (e.g., T-number, D-number, probe length/diameter) in the tool management system is missing or incorrect.
• Workpiece probe is physically damaged (e.g., stylus broken, internal wiring fault) or not properly mounted/connected to the measurement system.
• Probe activation sequence or M-function for enabling the probe (e.g., M-code for probe power-on) is not executed or fails.
• Parameters for workpiece probe functionality (e.g., MD20070 for probe type, MD20080 for measurement speed) are incorrectly configured.
• Signal path from the probe to the NC (e.g., wireless receiver fault, cable break, PLC input module error) is interrupted or noisy.

Klikk på steg for å spore fremgangen.

1. 1

   1. Check the tool management system for the active workpiece probe's T-number and D-number, verifying that all offset values (length, radius) are accurately entered.

2. 2

   2. Visually inspect the workpiece probe and its stylus for damage, and confirm it is securely mounted and clean.

3. 3

   3. Verify the M-function (e.g., M70, M71) or PLC output signal responsible for activating the probe, ensuring it is energized (e.g., 24VDC at the probe receiver).

4. 4

   4. Execute a probe calibration routine (if available) to test its functionality and update its offset data.

5. 5

   5. Check parameters related to the workpiece probe (e.g., MD20070 for probe type, MD20080 for probe measuring speed) against the probe's specifications.