Power unit: Configuration not supported

Hva betyr 230020 ?

This fault signifies that the requested configuration for the power unit is not supported by its hardware or firmware. Possible causes include requesting unsupported autonomous operation, an impermissible DRIVE-CLiQ timing, detection of an incompatible PM260 PS-ASIC version, or an incompatible combination of power unit and Control Unit/Adapter. Initialization failure due to premature Control Unit withdrawal can also trigger this. Operating with an unsupported configuration can lead to system instability, malfunction, or prevent the drive from starting altogether.

• Attempting to enable a function (e.g., 'Autonomous Operation Mode', P0111=1) that is not supported by the specific hardware variant or firmware version of the power unit.
• Mismatch between the configured drive type (e.g., P0100 parameter) in the engineering software and the actual hardware of the power unit.
• Firmware version of the power unit is outdated and does not support the specific features or configuration enabled in the project.
• Incorrectly attempting to operate the power unit without a compatible control unit (CU) if it requires one for specific configurations.
• Internal hardware component failure within the power unit, causing it to misidentify its capabilities or configuration.

Klikk på steg for å spore fremgangen.

1. 1

   Check the power unit's hardware version (e.g., on nameplate) and compare it with the selected hardware in the engineering software (e.g., STARTER/Tia Portal project).

2. 2

   Read out the firmware version of the power unit (r0018[0]) and consult the product manual for compatibility with the desired features.

3. 3

   Update the power unit's firmware to the latest compatible version using the engineering software's firmware update function.

4. 4

   Verify parameter P0100 (Motor type) and P0101 (Power unit type) are correctly set according to the installed power unit and motor.

5. 5

   Review the project configuration for any advanced features or operating modes (e.g., field weakening, P1300) that might not be supported by the current hardware/firmware combination.