Communication Error (Remote Display)

Hva betyr COM.E ?

This error occurs on the remote display terminal, indicating a communication timeout (50 ms) after 20 attempts to establish or maintain communication with the drive. This typically points to a faulty connection between the terminal and the drive, or incorrect communication settings, leading to a loss of display functionality and control.

• Loose, disconnected, or damaged communication cable between the remote display terminal and the drive's communication port.
• Incompatible firmware versions between the remote display and the drive, preventing proper data exchange.
• Incorrect communication parameters (e.g., address, baud rate) configured in either the remote display or the drive (if user-configurable).
• Excessive electromagnetic interference (EMI) on the communication lines causing data corruption and timeouts.
• Faulty communication port on either the remote display unit or the drive itself.

Klikk på steg for å spore fremgangen.

1. 1

   1. Inspect the communication cable connecting the remote display to the drive for any physical damage (cuts, pinches) or loose connections at both ends.

2. 2

   2. Verify that the remote display unit is correctly seated in its mounting slot or securely connected to the drive's communication port.

3. 3

   3. Check for strong sources of electromagnetic interference (EMI) near the communication cable; re-route the cable if necessary, ensuring proper shielding.

4. 4

   4. If configurable, verify that the communication address and baud rate settings on the remote display match those configured in the drive (e.g., P5-01, P5-02).

5. 5

   5. Attempt to connect a known-good, compatible remote display unit to the drive to determine if the issue is with the original display or the drive's communication port.