Address Setting Conflict

Hva betyr E46 ?

A conflict exists in the address settings of units on the network. This specifically occurs when a combination of automatic, manual, or remote control addressing modes are simultaneously used on one network, disrupting communication.

• Multiple indoor units assigned the same address (e.g., SW4 settings).
• Address setting conflict detected by the outdoor unit's controller.
• Improper setup of address switches or remote controller settings.

Klikk på steg for å spore fremgangen.

1. 1

   Review all indoor and outdoor unit address settings to ensure a consistent addressing method (e.g., all manual, or all auto where supported).

2. 2

   Verify that there are no duplicate addresses assigned to any unit on the network.

3. 3

   Refer to the system installation manual for proper addressing procedures for the specific system configuration.