No feedback of the laser by external control

Hva betyr NoExternMode- Possible ?

The LSRI_LsrExternEnabled signal, which indicates external control is enabled, is not being generated. This means the laser is not allowing external control, potentially because it's off, resetting, or in manual mode.

• Laser system not providing feedback for external control.
• Communication error with laser external control interface.
• Laser status signal not received by master controller.
• Laser is not in a state to accept external commands.
• External control mode not enabled on laser.

Klikk på steg for å spore fremgangen.

1. 1

   Verify that the laser system is switched on and powered.

2. 2

   Check if the laser is currently undergoing a reset sequence.

3. 3

   Confirm the laser is not in manual mode (refer to 'LsrInManual-Mode' resolution).

4. 4

   Verify the wiring and logic for the LSRI_LsrExternEnabled signal input.