Complete program will be continued without active process. Resumption with active process by executing LASER_INIT command

Hva betyr CompleteCold- Run ?

The system is configured to continue the program without an active laser process following a previous error, as selected in a dialog window. To resume with the active laser, a specific command is required.

• System initiated a cold run cycle, bypassing active process steps.
• Program completion without active process due to cold run selection.
• Requires LASER_INIT command to resume with active process.
• Cold run mode entered due to power interruption.
• Pre-programmed cold run sequence initiated.

Klikk på steg for å spore fremgangen.

1. 1

   Execute the LASER_INIT command from the robot controller to activate the laser process for program resumption.