Hardware fault, KPP/KSP (axis)

Hva betyr 26045 ?

The KPP or KSP device has detected an internal hardware fault. This indicates a critical issue within the device's internal electronics that requires direct attention to the component itself.

• Hardware malfunction detected in the KPP/KSP drive or associated control module.
• Encoder failure or signal loss for the axis.
• Motor driver fault within the KPP/KSP unit.
• Over-temperature condition within the KPP/KSP hardware.
• Internal communication error on the KPP/KSP bus.

Klikk på steg for å spore fremgangen.

1. 1

   Reinitialize the drive bus by performing a Power Off / Power On cycle of the entire system.

2. 2

   Check the specific KPP/KSP device's LEDs for further diagnostic information or specific fault indicators.

3. 3

   Exchange the defective KPP/KSP device, as the fault is internal hardware-related.