System Initialization Fault

Hva betyr 01 ?

The machine's system initialization has failed, preventing normal operation. This fault indicates a critical issue during startup and disables all motion functions.

• Failure during the machine's initial power-up sequence or self-test.
• Corrupted firmware or configuration data.
• Hardware malfunction affecting the main control unit.

Klikk på steg for å spore fremgangen.

1. 1

   Verify main supply voltage at the control unit input terminals against the specified nominal voltage range.

2. 2

   Inspect all internal control unit connections, including CPU, I/O modules, and safety circuit wiring, for proper seating and damage.

3. 3

   Check diagnostic LEDs on the main control board and any connected safety modules for specific error patterns or status indications.

4. 4

   Verify the status of critical safety chain inputs (e.g., door locks, emergency stops) to ensure they are in a closed and safe state, allowing system initialization.

5. 5

   Perform a controlled power cycle of the control system and carefully observe the boot sequence for any specific error messages on the display or changes in LED behavior.