NO DECIMAL POINT

Hva betyr PS5073 ?

This program error alarm is issued when a command, particularly for an extended axis name or within an execution macro, is specified without a decimal point in an address where one is required. This check is active if parameter 3404 bit #1 (POL) is set to 1.

• A numerical value in the CNC program block (e.g., X or Z coordinate) is missing a decimal point where one is required for accurate positioning.
• The control system expects a specific format for real numbers, and a missing decimal point prevents proper parsing of a coordinate or parameter value.
• This error can occur with G-codes that expect fractional values, such as G02/G03 for arcs or G92 for coordinate system setting.
• An input from an external device or a macro variable has been improperly formatted, lacking the necessary decimal separator.

Klikk på steg for å spore fremgangen.

1. 1

   Check parameter 3404 bit #1 (POL). Verify that it is set to 1, which enables the decimal point omission check.

2. 2

   Review the NC program block that caused the alarm. Locate the command that lacks a decimal point in an address where one is expected, paying close attention to extended axis names or execution macro commands.

3. 3

   Modify the NC program to include the decimal point in the identified command.