No Machining Cycle Found (Figure Block Only)

Hva betyr 3010 ?

This P/S alarm indicates that the control system could not find a valid machining cycle to execute. This occurs when the machining program specifies only a figure block without the necessary accompanying machining type block, making the intended operation undefined.

• The machining program only contains positional data (figure block) without a cutting cycle.
• No valid G-code command for a cutting operation was found in the sequence.
• The program is incomplete, missing essential machining commands.
• Attempting to execute a contour definition without a subsequent machining command.

Klikk på steg for å spore fremgangen.

1. 1

   Modify the machining program by adding the required machining type block to define the intended machining cycle.