Serial Pulse Coder Communication Error (DTER)

Hva betyr 300 ?

A communication error (DTER) was detected for the serial pulse coder. This can be caused by physical damage to the signal cable, a defective pulse coder or servo amplifier module, or external electrical noise interference.

• Discontinuity or damage in the serial pulse coder signal cable.
• Defective serial pulse coder.
• Defective servo amplifier module.
• External electrical noise interfering with serial communication.

Klikk på steg for å spore fremgangen.

1. 1

   Check the continuity and integrity of the serial pulse coder signal cable.

2. 2

   If the cable is verified as normal, replace the pulse coder or the servo amplifier module.

3. 3

   Implement noise reduction measures as described in the 'Descriptions' chapter on noise.