Power data not transferred correctly at power-up to DSP

Hva betyr 1794 ?

Essential power data failed to transfer correctly to the digital signal processor during drive power-up. This indicates a potential internal communication or data integrity issue that prevents proper initialization.

• Corruption of stored power section parameters (e.g., voltage, current limits) in non-volatile memory.
• Timing issue during the DSP boot sequence preventing proper data synchronization from the main processor.
• Internal communication bus error between the power section measurement unit and the DSP.
• Transient voltage dip on internal power rails during drive power-up, causing data integrity issues.
• Faulty or degraded internal sensor (e.g., voltage or current transducer) providing incorrect power data at startup.

Klikk på steg for å spore fremgangen.

1. 1

   Power cycle the drive by disconnecting mains voltage (L1, L2, L3) for at least 60 seconds.

2. 2

   Verify the stability of the main DC link voltage at terminals DC+ and DC- during power-up using a multimeter.

3. 3

   Ensure the drive firmware is updated to the latest stable version.

4. 4

   Perform a factory reset via Parameter P14-22 (Reset options) set to 2 (Load LCP defaults) to clear corrupted data.

5. 5

   Inspect internal ribbon cables connecting the power board to the control board for secure connections and damage.