Oversetter...
891

No position interface for %s-axis specified (%s).

Bosch Rexroth · Motion Control

Hva betyr 891 ?

The specified axis is configured as a feed axis in MACODA, but the position control interface is not configured in the main operation mode of the drive. This is a servo loop or drive fault, preventing proper position control for the axis.

Vanlige årsaker

  • Axis configured as feed axis in MACODA without position control configured in drive's main operation mode.

Reparasjonssteg & Sjekkliste

Klikk på steg for å spore fremgangen.

  1. 1

    Check ident number S-0-0032.

  2. 2

    Adjust the position control interface in the drive's main operation mode if necessary.

Se alle koder i denne manualen (60)
Verifisert teknisk data. Sist oppdatert: March 2026

Relaterte feilkoder

1287Error during generating the stack for the IdleTask.1288SERCOS state class 1: Overload cut-off %s-axis.1289SERCOS state class 1: Amplifier overtemperature cut-off %s-axis.
Kilde: Bosch Rexroth Motion Control
Open Manual (Page 65)Søk flere koder i denne manualen