Oversetter...
1340

Data error in %s (%s-axis).

Bosch Rexroth · Motion Control

Hva betyr 1340 ?

The drive does not accept the identification number provided in the SCS-file for the specified axis. This is a servo loop or drive fault, indicating a mismatch between the configured identification number and what the drive expects or supports.

Vanlige årsaker

  • Drive does not accept the identification number from the SCS-file for the %s-axis.

Reparasjonssteg & Sjekkliste

Klikk på steg for å spore fremgangen.

  1. 1

    Compare the identification number value specified in the SCS-file with the drive's minimum/maximum acceptable range.

Se alle koder i denne manualen (60)
Verifisert teknisk data. Sist oppdatert: March 2026

Relaterte feilkoder

1287Error during generating the stack for the IdleTask.1288SERCOS state class 1: Overload cut-off %s-axis.1289SERCOS state class 1: Amplifier overtemperature cut-off %s-axis.
Kilde: Bosch Rexroth Motion Control
Open Manual (Page 82)Søk flere koder i denne manualen