ENCODER A<>B

Hva betyr 7302 ?

The phasing of the pulse encoder connected to the ABB ACS800 drive is incorrect; specifically, phase A is connected to the terminal intended for phase B, and vice versa. This results in inverted or incorrect speed and position feedback (3.09 AW 2 bit 4), leading to motor instability or incorrect direction of rotation.

• Incorrect wiring of pulse encoder phases A and B at the drive's encoder input terminals or the encoder interface module terminals.
• Accidental swapping of encoder signal wires during installation or maintenance.

Klikk på steg for å spore fremgangen.

1. 1

   Verify the pulse encoder wiring against the ABB ACS800 drive's wiring diagram and the encoder manufacturer's documentation, paying close attention to phase A and B connections.

2. 2

   Physically interchange the connections of pulse encoder phases A and B at the drive's encoder input terminals (or the interface module, if applicable).

3. 3

   After re-wiring, perform a motor ID run or utilize the drive's monitoring parameters to check the encoder feedback and confirm correct phasing and motor rotation direction.