NO DECIMAL POINT

What does PS5073 mean?

This program error alarm is issued when a command, particularly for an extended axis name or within an execution macro, is specified without a decimal point in an address where one is required. This check is active if parameter 3404 bit #1 (POL) is set to 1.

1. 1

   Check parameter 3404 bit #1 (POL). Verify that it is set to 1, which enables the decimal point omission check.

2. 2

   Review the NC program block that caused the alarm. Locate the command that lacks a decimal point in an address where one is expected, paying close attention to extended axis names or execution macro commands.

3. 3

   Modify the NC program to include the decimal point in the identified command.