Function / Parameter Not Implemented

¿Qué significa 8.0.00.11 ?

The specific function or parameter being requested is not implemented in the current inverter's firmware or hardware configuration. This can occur if the inverter unit does not support a particular feature, or if a required optional module is missing. The requested operation cannot be performed.

• Attempting to use a feature (e.g., specific braking mode, advanced control algorithm) that requires an optional hardware module (e.g., braking resistor module, encoder option card) which is not installed.
• Requesting access to a parameter (e.g., P5-10 for an advanced motion profile) that is only available in a higher-tier inverter model or a newer firmware revision than the current unit.
• A legacy PLC program attempting to set a parameter that has been deprecated or replaced by a different parameter in a newer inverter firmware version.

Haga clic en los pasos para seguir su progreso.

1. 1

   Verify the inverter model, firmware version, and installed option cards against the feature requirements for the desired parameter or function (e.g., confirm option card X30 is present for advanced I/O).

2. 2

   Review the inverter's parameter manual (specific to the installed firmware version) to confirm the existence and availability of the parameter in question.

3. 3

   Consider upgrading the inverter's firmware to a newer version (if available and compatible) that includes the desired functionality, following manufacturer guidelines and backup procedures.

4. 4

   If the function requires an optional hardware module, identify and install the correct module (e.g., encoder feedback card) into the designated slot (e.g., slot A or B) as per the installation manual.

5. 5

   Modify the control program (PLC/HMI) to only use parameters and functions supported by the current inverter hardware and firmware configuration (e.g., changing P5-10 to P5-01 if 5-10 is not implemented).