Ground fault

¿Qué significa F-03 ?

A ground fault has been detected in the motor, its supply lead, or within the MOVITRAC® B inverter itself, causing an immediate switch-off with inhibit. This is a critical safety and equipment protection issue. Unresolved ground faults can lead to severe damage or safety hazards.

• Insulation breakdown between a motor phase winding and its frame (ground), creating a low resistance path.
• Damage to motor output cable insulation allowing a phase conductor to touch ground (e.g., damaged conduit or gland).
• Water or excessive moisture ingress into the motor terminal box or inverter enclosure, reducing insulation resistance.
• Inverter internal ground fault due to component failure or contamination (e.g., dust, metallic particles on PCB).
• Improper grounding of the motor frame or cable shielding, leading to current leakage detection.

Haga clic en los pasos para seguir su progreso.

1. 1

   1. Disconnect the motor cable from the inverter output (U, V, W) and measure insulation resistance from each phase to ground (expect >10 Mohms).

2. 2

   2. Visually inspect the motor terminal box and cable glands for moisture, corrosion, or insulation damage.

3. 3

   3. Verify that the motor frame is properly grounded (e.g., resistance to protective earth <1 Ohm) according to local electrical codes.

4. 4

   4. If the fault clears with the motor disconnected, focus troubleshooting on the motor and cabling; if the fault persists, suspect an inverter internal issue.

5. 5

   5. Use a megohmmeter (e.g., 1000V DC) to test insulation of motor windings and the motor cable to ground and between phases.