Digital Servo System is Abnormal

¿Qué significa 414 ?

This is a general alarm indicating a broad abnormality within the digital servo system of the Fanuc Series 20 CNC. It suggests a fundamental issue with the communication or control of the digital servo amplifier, possibly related to internal processing or data integrity.

• Internal fault within the digital servo amplifier.
• Communication error between the CNC and the servo amplifier (e.g., corrupted serial data link).
• Faulty servo control board in the CNC.
• Incorrect configuration or critical servo parameters.
• Electrical noise impacting the digital communication lines.

Haga clic en los pasos para seguir su progreso.

1. 1

   Check the status LEDs on the digital servo amplifier for any specific fault codes and consult the amplifier's manual for detailed diagnostics.

2. 2

   Power cycle the CNC and all servo amplifiers to reset the digital servo system.

3. 3

   Inspect the serial communication cables (e.g., fiber optic or twisted pair) between the CNC and servo amplifiers for damage or loose connections.

4. 4

   Verify critical servo parameters are correctly set and have not been corrupted.

5. 5

   If possible, swap the suspected servo amplifier or the servo control board in the CNC with a known good one to isolate the issue.