Parameter read only

¿Qué significa 89 ?

An attempt was made to write a value to a parameter that is configured as read-only. This typically occurs when trying to change system information, diagnostic values, or parameters that can only be modified internally by the drive, protecting critical settings.

• Attempting to modify a system information parameter (e.g., drive serial number, firmware version in Parameter 15-05) which is inherently read-only.
• Parameter is a diagnostic output value (e.g., motor current, output frequency in Parameter 16-10) which reflects real-time status and cannot be set.
• Parameter access level (e.g., Parameter 16-00, 'Access code') is not set high enough to allow modification of protected parameters.
• Parameter is part of an active process (e.g., autotuning via Parameter 8-00) and becomes read-only during that operation.
• Control mode (e.g., Parameter 1-00) prevents writing to certain motion-related parameters while active.

Haga clic en los pasos para seguir su progreso.

1. 1

   Verify the parameter number and check its attributes in the drive's programming manual to confirm if it is indeed read-only.

2. 2

   Adjust the access level (e.g., set Parameter 16-00 to '3 - Advanced' or '4 - Expert') to enable writing to protected parameters.

3. 3

   Ensure the drive is in a stopped state (output frequency at 0 Hz) before attempting to modify parameters related to motor control.

4. 4

   Check if any special functions (e.g., Parameter 8-00, 'Auto-tune') are active and causing the parameter to be temporarily read-only.

5. 5

   If attempting to modify a diagnostic value, understand that these are outputs and cannot be directly set; interpret them for troubleshooting.