NVS Not Blank

¿Qué significa 102 ?

An internal data error in the non-volatile storage (NVS) is detected, implying that the NVS is not in its expected blank or clean state. This condition can prevent proper drive initialization or parameter loading. If left unresolved, the drive may fail to start, retain configuration, or operate reliably.

• Previous unsuccessful attempt to clear or format the non-volatile storage, leaving residual data.
• Partial corruption remaining in NVS from a prior fault or power disturbance, preventing a clean state.
• Internal NVS hardware fault preventing the drive from detecting a blank or initialized state.
• Firmware bug related to NVS initialization routines upon power-up.
• Incomplete write cycles to the NVS, leaving fragmented or unexpected data.

Haga clic en los pasos para seguir su progreso.

1. 1

   1. Perform a drive power cycle by disconnecting input power (e.g., 480VAC) for at least 30 seconds, then reapply.

2. 2

   2. Attempt a full parameter reset to factory defaults via the HMI or software (e.g., set P0-01 to "Factory Reset").

3. 3

   3. Re-attempt a firmware update for the main control board, ensuring the process completes without interruption.

4. 4

   4. Verify the integrity of the main control board (MCB) connections to the power board backplane for proper communication.

5. 5

   5. If the issue persists, the main control board (MCB) likely has a damaged non-volatile storage module and requires replacement.