Function Incompatible with Control Mode

Was bedeutet oPE08 ?

A parameter or function has been configured that is not supported or compatible with the currently selected control mode of the drive. This error often arises after a control mode change, requiring a thorough review of parameter settings to match the new mode of operation.

• Drive control method (Parameter A1-02, e.g., V/f, Sensorless Vector, Closed Loop Vector) was changed, and a previously configured parameter is incompatible with the new mode.
• Attempting to use advanced motor control functions (e.g., flux vector tuning, auto-tuning) while the drive is set to a basic V/f control mode.
• PID function (e.g., b3-01) is enabled or configured, but the selected control mode (A1-02) does not support integrated PID.
• Specific output functions (e.g., pulse output, specific relay functions) are not available in the currently selected control mode.

Klicken Sie auf Schritte, um Ihren Fortschritt zu verfolgen.

1. 1

   1. Identify the currently selected drive control method by checking Parameter A1-02.

2. 2

   2. Determine which specific parameter or function (often indicated by the fault message or recent changes) is causing the incompatibility.

3. 3

   3. Refer to the drive's programming manual to verify which parameters and functions are compatible with the control mode set in A1-02.

4. 4

   4. Either change the incompatible parameter/function to a compatible setting or adjust Parameter A1-02 to a control mode that supports the desired function.

5. 5

   5. Perform a parameter initialization (Parameter A1-03) to reset all parameters to default for the current control mode, then reconfigure from scratch if necessary.

6. 6

   6. Perform a drive power cycle after setting the parameters.