Opt External Flt

Was bedeutet EF0 ?

An external fault condition exists, originating from the communication option card. This suggests an issue with an external device or signal connected via the option card, potentially leading to incorrect drive operation. This can also appear as a flashing alarm.

• An external safety device (e.g., E-stop, limit switch) connected to the option card has tripped or changed state.
• Broken or damaged wiring between the communication option card and the external fault source.
• Incorrect configuration of the digital input on the option card (e.g., normally open vs. normally closed logic).
• Loss of auxiliary power to the external device providing the fault signal to the option card.
• Communication timeout or error from the master controller (e.g., PLC) to the drive's option card.

Klicken Sie auf Schritte, um Ihren Fortschritt zu verfolgen.

1. 1

   1. Verify the status of all external devices connected to the option card's fault input terminals.

2. 2

   2. Using a multimeter, test continuity of wiring from the option card's fault input terminals to the external fault source.

3. 3

   3. Confirm the correct parameter settings for the option card's fault input logic and assignment (e.g., input type, debounce time).

4. 4

   4. Check diagnostic LEDs on the option card (if available) for specific indications of external fault status.

5. 5

   5. Temporarily disconnect the external fault signal from the option card's input to determine if the fault is external or internal.