SFC Program End Error

Was bedeutet 1020 ?

The SFC (Sequential Function Chart) program cannot be terminated normally. This issue may be caused by electrical noise interference or other unspecified reasons preventing the SFC program from concluding its execution sequence.

• SFC program cannot be normally terminated due to noise.
• SFC program cannot be normally terminated for any other reason.

Klicken Sie auf Schritte, um Ihren Fortschritt zu verfolgen.

1. 1

   Implement noise reduction measures for the control system environment.

2. 2

   Reset the CPU module and attempt to RUN it again.

3. 3

   If the same error is displayed again after resetting, diagnose for a CPU module hardware fault.