Speed control error

Was bedeutet nErr ?

The motor speed is out of the tolerance margin defined by C0576. This typically occurs due to an excessively high active load (e.g., in hoists) or mechanical blockades, preventing the drive from achieving the commanded speed.

• Mechanical overload on the motor exceeding its rated torque, preventing it from reaching the commanded speed.
• Motor or gearbox mechanical damage (e.g., worn bearings, seized components) creating excessive friction or resistance.
• Incorrectly tuned speed controller (e.g., P-gain P1-10 too low, I-gain P1-11 too low), resulting in sluggish response to load changes.
• Loss of motor feedback (encoder, resolver) signal or noisy feedback, causing the speed controller to lose track of actual speed.
• Insufficient motor torque capacity (e.g., parameter P3-00 motor nominal current too low) for the application's load requirements.

Klicken Sie auf Schritte, um Ihren Fortschritt zu verfolgen.

1. 1

   Reduce the mechanical load on the motor and observe if the speed error clears; verify the application's torque requirements are within motor limits.

2. 2

   Inspect the motor, gearbox, and connected mechanical system for any binding, damage, or blockades.

3. 3

   Adjust speed controller tuning parameters (P1-10, P1-11) by increasing P-gain and/or I-gain in small increments to improve responsiveness.

4. 4

   Verify the integrity of the motor feedback sensor (encoder/resolver) cabling (e.g., at X7 or X9) and signal quality using an oscilloscope.

5. 5

   Check motor parameters (P3-00 to P3-04) against the motor nameplate data, especially motor nominal current and rated speed.

6. 6

   Increase the speed error tolerance margin C0576 temporarily for diagnostic purposes, then retune the controller for stricter limits.