Max. following error exceeded ({Drive})

Was bedeutet 26024 ?

The deviation between the commanded position and the actual position for the specified drive ({Drive}) has exceeded the maximum allowable limit. This often occurs in torque mode operations if regular monitoring functions are not appropriately deactivated, or due to external mechanical resistance.

• Excessive deviation between commanded and actual position for the specified drive ({Drive})
• Regular monitoring functions remaining active during torque mode operations when they should be deactivated
• Mechanical load or obstruction on the specified drive ({Drive}) preventing accurate positioning

Klicken Sie auf Schritte, um Ihren Fortschritt zu verfolgen.

1. 1

   If torque mode is intentionally active, verify that regular monitoring functions are deactivated using SET_TORQUE_LIMITS(..., monitor #off)

2. 2

   Investigate mechanical load or obstruction on the specified drive ({Drive}) that might be causing position deviation

3. 3

   Check for correct tuning of the drive's position control loop