Spindle Control Software Error (30i Range 1)

Was bedeutet SP1976 ?

An error occurred with the spindle control software for Series 30i (codes SP1976 to SP1979). This indicates an internal software issue requiring system diagnosis.

• Internal software error within the spindle control firmware (30i range).
• Data corruption in the spindle control program memory.
• Unstable power supply to the spindle control module.
• Hardware fault on the spindle control board.
• Incorrect configuration of spindle control parameters.

Klicken Sie auf Schritte, um Ihren Fortschritt zu verfolgen.

1. 1

   Power cycle the entire CNC system to reset the spindle control software.

2. 2

   Verify that the correct firmware version is installed for the spindle control module.

3. 3

   Check all power and ground connections to the spindle control board.

4. 4

   Run the spindle control module's built-in diagnostic tests.

5. 5

   Reset spindle control parameters to their default values if possible.