I1 Flash Failed

Was bedeutet 10137 ?

An attempt to flash the FPGA configuration device on port 1 has failed. This indicates a problem with the firmware update process, potentially leaving the device in an inoperable state.

• Interruption of power (e.g., sag, complete loss) during the FPGA flashing process on Port 1, leading to a corrupted firmware image.
• Incompatible or corrupted firmware file used for the update attempt on Port 1, not matching the specific FPGA device or board revision.
• Failure of the JTAG interface, SPI bus, or other programming interface used to communicate with the FPGA on Port 1 (e.g., broken traces, faulty connector).
• Hardware defect on the FPGA chip itself or its supporting memory components on Port 1 (e.g., bad sector in configuration memory).
• Improper software tool or incorrect settings (e.g., wrong baud rate, incorrect device ID) used during the flash operation for Port 1.

Klicken Sie auf Schritte, um Ihren Fortschritt zu verfolgen.

1. 1

   1. Verify the drive's input power supply is stable and within specified voltage limits (e.g., 400VAC +/- 10%) before attempting any firmware update.

2. 2

   2. Obtain the correct and verified firmware file specifically for the drive model and revision, then re-attempt the flash procedure for Port 1.

3. 3

   3. Check the integrity of the programming cable (e.g., USB, Ethernet, JTAG) and ensure it is securely connected between the PC and the drive's programming port for Port 1.

4. 4

   4. Confirm the version and compatibility of the flashing software tool, ensuring it is the recommended version for the target firmware and hardware on Port 1.

5. 5

   5. Inspect the FPGA component and surrounding circuitry on the Port 1 board for any physical damage, discolored pins, or signs of overheating.