Failed Max Wait Run

Was bedeutet E3-16128 ?

The I/O bus module failed to complete its maximum allowed wait run time. This indicates a significant delay in processing or a communication deadlock, potentially causing I/O operations to time out and impacting system responsiveness or control. It suggests a performance or communication bottleneck.

• Excessive communication latency or dropped packets on the industrial bus (e.g., EtherCAT, Profinet) due to network congestion or faulty cabling.
• Master controller (PLC) experiencing high CPU load or critical tasks delaying cyclic I/O updates to the module beyond the configured watchdog time.
• I/O module firmware internal processing deadlock or slow response to bus requests, preventing timely handshake.
• Incorrectly configured bus watchdog timer parameter (e.g., P50-01 'Bus Timeout') in the controller, set too short for the network conditions.
• Physical damage or impedance mismatch on the bus communication lines (e.g., RS485, Ethernet) causing data corruption and retransmissions.

Klicken Sie auf Schritte, um Ihren Fortschritt zu verfolgen.

1. 1

   1. Verify the integrity of the industrial network cabling (e.g., CAT5e Ethernet patch cable) between the controller and the I/O module. Check for bends or cuts.

2. 2

   2. Monitor the CPU load and cycle time of the master PLC/controller using the programming software (e.g., TIA Portal online diagnostics).

3. 3

   3. Access the I/O module's configuration in the controller software and review the bus communication timeout settings (e.g., P50-01). Increase it slightly if network latency is expected.

4. 4

   4. Observe the network status LEDs (e.g., Link, Activity) on both the I/O module and the bus master to identify intermittent communication loss.

5. 5

   5. Isolate the I/O module by temporarily connecting it directly to the bus master (if applicable) to rule out issues with intermediate network devices (e.g., switches, couplers).